Looking for a good program to make nice schematics, but ended up just doing it long-hand written out a bit better... Maybe.
It will be for the JAMO classic 8. This is what I’m gathering from the photo and supplied photo. Been years, but anyone can check my work, please. I’m happy to explain if needed, or answer questions. Also welcome to send me a PM of you need assistance or have a question about placing the components .
In a nut shell, make sure the inductors are not laying flat. If so, then make sure they are about 8 inches away from each other. Other wise, lay big one down, make sure mid rolls into, and smaller one lay down. This will mean you’ll only need about 4 inches apart. I don’t have the components to lay out, but again welcome to work something out if you need assembly help.
I tried to Mark things more to standard (if I recall right) as well trying not to go over head and allow you to see better where things hook up. If that drawing you gave me is right.
Dotted lines are just trying to show second woofer wire location. Again, both lower woofers share connections. Both are hooked same way, same spot. The mid and tweeter share a little then break out.
Try and run 1 negative line from terminal to speaker. You can cut the jacket off the wire say about 2 inches where needed then solder to wire without cutting. It keeps the chain solid! Sorry being yelled at this second. Have to run!
Happy bunny day