[James Tanner]

Hi Chris - email Adam - atanner@bryston.com

james

[Chris Cheung]

no feedback

[James Tanner]

Chris - can you send me your email please - jamestanner@bryston.com

james

[Chris Cheung]

Thanks Adam & Chris help to solve the hang up problem by service mode. My BDP-1 is running in Roon Ready mode healthily now. Thanks a lot.

[Matt Cooney]

Hi James,
I put in an email to support, but pinging here too.  Odd problem with by BDP-2.  In seems to operate correctly in all respects but will not play a song.  It will cue songs up correctly, and all other buttons seem to act correctly, but it literally will not start to play the song (clock remains at zero seconds, as opposed to playing but have a subsequent signal issue).  Same problem whether operating MPD or using front panel.  I have made sure firmware is updated and restarted.
Thanks
Matt

[Jozsef]

I had this happen just a couple of weeks ago. Unplugging it for 30 seconds was not effective but ten or fifteen minutes did the trick and it's been working correctly ever since. They do like to have power free from glitches but I don't now recall precisely what sorts of anomalies effect them.

[Matt Cooney]

Thank you for that tip!  I did try unplugging for a while, but not very long.  I have been making system changes lately that maybe caused a glitch.

[ttsto]

Hi, posting here a problem and solution I found related to NAS not being discovered
I own BDP1 and music is stored on QNAP NAS TS451A. Recently I upgraded the firmware of the NAS (many versions) to 5.01 and following this BDP1 was not able to access the music shared folder, sometime showing this error:

failed to connect:mount error(95): Operation not supported Refer to the mount.cifs( manual page (e.g. man mount.cifs)
sudo mount -t cifs -o username='xxxxxxx',password='xxxxxxxx',uid=106 "\\\\1xx.1xx.xx.xx\\Music" "/media/Music_on_MediaCenter.local" 2>&1

Looking how to solve it I found reference that it may with a older version of SMB protocol and indeed, my NAS had a setting to allow discovery only via SMB3 and SMB2.

When I changed it to SMB1 NAS setup worked and I can enjoy music again.

I wanted to share this with technical staff from Bryston, maybe they will consider upgrading the SMB protocol, and with any of you who had / will have similar problem

[freshaudio]

Hello members! What is the purpose of the 5vdc bus from psu board to the main board on BDP-1/2/3?
I lifted this bus then it seems I have better audio quality when streaming Qobuz/Tidal on my BDP-1.