[bundee1]

I'm halfway done with my mods. I've replaced all the amp board caps and I'm waiting on massive 63v 15000uf BHC power supply caps. I want to remove the stock RCA inputs and bypass the lousy volume pots. I know I can yank out the volume pot board but then I get lost after replacing the RCA inputs. I know I have to solder the wire the amp board at the input capacitor leads. I was told I would need to solder a 47k resistor at the posiive lead or something. Can anyone walk me through this one?

[bundee1]

Here's the schematic and I know enough to see the pertinent info is on page 2 but I dont know how to connect the parts and if they are all necessary if Im going straight from the RCA inputs to the amp board.

http://www.mediafire.com/?q1m2nd3ohdz

I already have the 2.2 caps replaced on the board now where do the two resistors go and what values are they?