« previous next »
Pages: [1]   Go Down

Help with Teac AL700P mods esp RCA mod

0 Members and 1 Guest are viewing this topic. Read 981 times.

bundee1

  • Full Member
  • Posts: 361
Help with Teac AL700P mods esp RCA mod
« on: 4 Apr 2010, 11:12 pm »
I'm halfway done with my mods. I've replaced all the amp board caps and I'm waiting on massive 63v 15000uf BHC power supply caps. I want to remove the stock RCA inputs and bypass the lousy volume pots. I know I can yank out the volume pot board but then I get lost after replacing the RCA inputs. I know I have to solder the wire the amp board at the input capacitor leads. I was told I would need to solder a 47k resistor at the posiive lead or something. Can anyone walk me through this one?
Logged

bundee1

  • Full Member
  • Posts: 361
Re: Help with Teac AL700P mods esp RCA mod
« Reply #1 on: 6 Apr 2010, 01:04 am »
Here's the schematic and I know enough to see the pertinent info is on page 2 but I dont know how to connect the parts and if they are all necessary if Im going straight from the RCA inputs to the amp board.

http://www.mediafire.com/?q1m2nd3ohdz

I already have the 2.2 caps replaced on the board now where do the two resistors go and what values are they?

Logged
Pages: [1]   Go Up
« previous next »