« previous next »
Pages: [1]   Go Down

NuForce Icon as mono amp?

0 Members and 1 Guest are viewing this topic. Read 953 times.

LFord

  • Jr. Member
  • Posts: 10
NuForce Icon as mono amp?
« on: 27 Jul 2009, 03:03 pm »
I'm wondering if the Icon could be used as a mono amp.  If you brought a mono signal into both the RCAs via a Y-cable and tied the speaker outputs together, would this pseudo-bridge work?  I'm assuming a nominal 8-ohm speaker.

Thanks,
Lou
Logged

nuforce-casey

  • Industry Participant
  • Posts: 357
Re: NuForce Icon as mono amp?
« Reply #1 on: 29 Jul 2009, 05:36 pm »
Unfortunately, this will not work, you'll destroy the Icon's output stage right away.
Logged

LFord

  • Jr. Member
  • Posts: 10
Re: NuForce Icon as mono amp?
« Reply #2 on: 29 Jul 2009, 07:19 pm »
Ah, then we won't do that.  :nono:

What about running just one channel?  Does it get upset if there's not a load on one channel?

Thanks,
Lou
Logged
Pages: [1]   Go Up
« previous next »