[2wo]

I will try to link an image. If I get I will come back and explain it





OK, so that kind of worked. I went and bought two pair of the Signal transformers to build my own Felicia.  I salvaged what I thought was an old UPS to use as a chassis.

Well, well, look what I found when I opened it. That isolation trans is about 10" across and rated  for 15 A

Gee what to do now? Any thoughts?…John   

[Occam]

John,

I split your post into another thread. I assume that big toroid is an isolation transformer. (I'm also assuming that the metalic bolt in its center has an insulating bushing at the bottom to prevent a 'shorted turn'). Could you post some more information? What is the make and model #. How is the transformer? hooked up; how many leads, is there a green or green/yellow striped wire coming from the toroid and what is it connected to?

Regards,
Paul

[2wo]

Thanks Paul,

Yes it’s an Isolation trans, not balanced, Two leads in, two out. There is a filter network on the output two 15uf caps from hot-neutral-ground and a resistor small cap in there as well. I have not had a chance to take it out and trace it out. 

The center bolt was insulated but it made me nervous and I have already removed it.

I think it will work well for my power amp. Now I am looking to integrate  it with my low power  stuff. Maybe carry on with  the Felicia or maybe add a couple of CMC to the output outlets…John