T amp bridged to mono?

Christof · « **on:** 7 Feb 2006, 06:14 am »

Is it possible to make monoblocks from the Sonic Impact Super T amps?

thx...c.

Folsom · « **Reply #1 on:** 7 Feb 2006, 06:31 am »

If I am not mistaken they are not suppose to be bridged.... There for I doubt there would be a point.

Christof · « **Reply #2 on:** 7 Feb 2006, 02:08 pm »

Can a T-amp be run with no load on one of it's channels? I'm building a temporary HT system with Abby clones and would like to power the whole thing with Son of T amps but what do I do when it comes to my center channel?

Thx
c.

Vinnie R. · « **Reply #3 on:** 7 Feb 2006, 03:35 pm »

Quote from: Christof

Can a T-amp be run with no load on one of it's channels? I'm building a temporary HT system with Abby clones and would like to power the whole thing with Son of T amps but what do I do when it comes to my center channel?

Thx
c.

Hi C.

You cannot bridge the Sonic T-Amps...they are already running in a bridge mode for each of the two channels.

Yes, you can one channel with no load....it will not hurt anything.

Regards,

larry99 · « **Reply #4 on:** 7 Feb 2006, 05:22 pm »

Or convert your center speaker to a bi-ampable configuration. Use one channel for the bass and the other for the mid/tweeters.

Christof · « **Reply #5 on:** 8 Feb 2006, 04:30 am »

Thanks for clarification.
cg.