[cynadon]

A370PEQ plate amp. Triple sub / middle reversed. Subs play when I disconnect servos. Don't find any shorts on the speaker end. Donesn't seem to have output at amp. I don't see any magic smoke marks, solder, swells, cracks or anything. I haven't had time to probe with the scope yet. I was wondering if anybody has had to replace  the servo board? part #081073042

jason
[email protected]

[TRADERXFAN]

Not had to replace, but I did get a swap for a different servo board with a different slope from Brian at Rythmik. they are a little socket board that you can disconnect. Do you have a pair of these or a single set? if a pair you might swap the good one out for it and see if that fixes it.

[cynadon]

No I have only one speaker/amp.  I probed around with my oscope a little. I dont get anything from the pins of the ribbon connector

[HAL]

Were the servo sub working earlier, or is this their first startup?

[Danny Richie]

If you can't get it figured out then contact Brian and Rythmik Audio and he will help you get it sorted our or will replace it.

[jmimac351]

I had one of these fail on an F8 amp (HX580) and was able to get in touch with Brian before the holidays.  He sent a document over to remove the amp properly, wiring, etc.  Let me know if you need it. 

If you look on his site, his number ends in 3712.

[Nick B]

Had an issue with a Rythmik sub and Brian took care of it very quickly. Great service and turn around time as I was unable to remove the board