How does this all Visaton Open Baffle design look?

0 Members and 1 Guest are viewing this topic. Read 269 times.

DaveFred

  • Jr. Member
  • Posts: 9
How does this all Visaton Open Baffle design look?
« on: 23 Jul 2019, 02:10 am »
I have been trying different baffle layouts where I can place the drivers all in the centre so their radiation patterns are symmetrical, and this is what I have come up with.





What do you think of this layout?





About the tweeter, do you think I am crossing the G20SC too low, or does it look fine?





For the crossover, I have used real values for everything of components I can source locally with correct OHM resistance for each. I used a 16g laminated steel inductor on the woofer and for the 10mH on the mid, everything else is 18g air core.

How accurate is Boxsim on open baffle designs like this?

I used the instructions from Rudolf on how to set up Boxsim for open baffle designs.

Is there a way I can upload the Boxsim .BPJ file for you to look at as well?

Comments?

Thank you,

David

FullRangeMan

  • Volunteer
  • Posts: 12053
  • All Tweeters look like a target, then shoot them!
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: How does this all Visaton Open Baffle design look?
« Reply #1 on: 23 Jul 2019, 02:24 am »
When you said all Visaton I think was an all B200 system,
This LA was made by an AC member:

JohnR

Re: How does this all Visaton Open Baffle design look?
« Reply #2 on: 23 Jul 2019, 06:01 am »
Well, it looks pretty good, your simulation is based on measurements of the drivers? I suppose the main limitation would be SPL at low frequencies.

BTW I added the WS 25E to the list of OB drivers  :thumb: