0 Members and 1 Guest are viewing this topic. Read 28358 times.
The output wires are going to be very close to the umbilical from the NC400 > SMPS. Not so sure I would do that...
What PCB?Me, thanks.
If you don't mind, how does one do stenciling?Thanks
Hi James,I've recently stumbled upon this site and read your thread with interest. I might fancy a couple myself. Just a couple of questions:Has the layout changed again, I thought the favourite was now the one in reply #136; seems to make the most sense to me...
What is the situation with the lazer engraving; what will it cost and can one have it without the white powder, i.e. just the engraving?
Page created in 0.051 seconds with 28 queries.