NX-Studio build

0 Members and 1 Guest are viewing this topic. Read 1003 times.

Tyson

Re: NX-Studio build
« Reply #20 on: 11 Oct 2021, 03:30 pm »
But all my speaker cables are terminated with spades right now...

Just cut the spades off, strip back the wires and terminate them to high quality banana's like the WBT low mass high purity copper or high purity silver.  It's pretty easy.

mlundy57

  • Industry Participant
  • Posts: 3133
Re: NX-Studio build
« Reply #21 on: 11 Oct 2021, 05:21 pm »
Or cut the spades off and install the male tube connector studs. If you need additional male studs, Danny can provide them

petemoss

  • Jr. Member
  • Posts: 31
Re: NX-Studio build
« Reply #22 on: 14 Oct 2021, 12:25 am »
Thanks for the cool picture Hobbs!

I think I'll ask a flat +$120 (+$200 total...$80 is built into the cost of the kit) for all species.

That'll be for maple, mahogany, cherry, and walnut.

They will be sold unfinished so that you can pick what finish you'd like and not have to worry about squeeze out or small scrapes during assembly.

We've been using Rubio Monocoat to great success and I'd recommend using it for finishing these baffles!

So if we already have the kit and want to buy these for it...would the cost be $200?