Aurasound NS3 measurement

0 Members and 1 Guest are viewing this topic. Read 2944 times.

JohnR

Aurasound NS3 measurement
« on: 3 Oct 2011, 03:46 am »
On-axis, and off-axis 30 and 60 degrees:



Box is 10 cm wide, so the diffraction peak is a bit above 2k.
 
In-room response - bass in sealed box seems to be -3 dB at around 85 Hz as predicted by the model:



Not bad for a $12 driver.

(Note: these ones have been sitting on a shelf for years. So the current ones may be different for all I know.)

Any comments or thoughts appreciated :thumb:

JohnR

Re: Aurasound NS3 measurement
« Reply #1 on: 25 Oct 2011, 10:39 am »
I've spent the time since listening to these in a computer/desk setup. Stonking bargain. Assuming you don't mind a bit of EQ, but then again I'm starting to think that about all speakers...  :peek:

Raiderone

  • Jr. Member
  • Posts: 47
Re: Aurasound NS3 measurement
« Reply #2 on: 25 Oct 2011, 11:09 pm »
Thanks for the post.

How big are the cabinets?

Yeah, most speakers need some type of eq.  I like the adding another driver eq; buy two pair, run one under the other, roll off with single inductor (hopefully).

JohnR

Re: Aurasound NS3 measurement
« Reply #3 on: 26 Oct 2011, 01:14 am »
Pretty small, about 2.5 liters sealed. It was one I had before. Not a lot of low bass obviously.

Two drivers is a good suggestion. Maybe a bipole would work too.