[cujobob]

I just recently purchased this from someone on this forum, but some home repairs in the last week are forcing me to sell.


Up for sale is a Dodd Buffer kit with Platinum cap upgrade.  In a nice all metal enclosure, battery/charger obviously not included.  12ax7 tube included.

Pic from the build before being sent to me.

 One more of the front:



$420 + Shipping (from 48093)/Paypal

[cujobob]

Lowered price a bit, if no takers I'll keep it.   

[morganc]

Is this the same chassis minus the faceplate that you get if you buy the pre-made version from Dodd? 

Also, does anyone know hard it is to install the remote control option?

Thanks,
Morgan

[TrungT]

Morgan
The chassis is a DIY chassis http://www.circuitspecialists.com/prod.itml/icOid/6424
The remote unit is easy to install.
Any help you need just drop a note.

[morganc]

I have two questions:
1.  Can you use the nice Dodd wooden face plate on this chassis?
2.  Will this unit take the 6h30 tube or is that a special mod?

Thanks guys,
Morgan

[TrungT]

^^^^^
No, this chassis has a difference size of the Dodd buffer.
Yes, this buffer is 6H30 ready.
But, Randall Kepley who is a member here on A.C can put it in a nice wooden box.

[morganc]

^^^^^
No, this chassis has a difference size of the Dodd buffer.
Yes, this buffer is 6H30 ready.
But, Randall Kepley who is a member here on A.C can put it in a nice wooden box.

Thanks Trung...that is a good point.......I will send Randall a PM.....and if it works out, I will get this or a similar buffer....

[TrungT]

^^^^^
You'r welcome 
This buffer is great deal.

[hagar]

Hello cujobob,
I sent you a PM

cheers
Simon

[morganc]

Hello cujobob,
I sent you a PM

cheers
Simon

I just got mine Simon....highly recommended:)

[hagar]

Hello Morgan,
did you get the one from this offer or another unit?
Haven´t got an answer to my PM to cujobob  yet.....
I was looking for an autoformer pre but the Dodd buffer seems to be very insteresting,too(especially at the dollar/euro exchange rate at the moment) .

cheers
Simon

[morganc]

No I got another fully built unit as I prefer to listen, rather than hurt myself .   I was always good at detroying electronics, and not so good at the building process, however I should add that I am sure Gary and Trung could easily walk you through the build process very easily. 

And btw, this sounds awesome right out of the box.

[cujobob]

Bump...haven't been pushing it too hard as I've been so busy, but need to move it soon!

[cujobob]

$400 + shipping/paypal

As low as I'm willing to go on this one...   

[bladesmith]

PM sent...

[bladesmith]

$400 + shipping/paypal

As low as I'm willing to go on this one...   

Just Need you to email me the total ($400 + shipping to 66047 + PayPal fee = ? )
with your PayPal address and and I'll send you the money today...!

thanks..