[lofreek]

It started out as a Lenco L75 and I just had to go all in.

[toxteth ogrady]

Outstanding build! That thing probably sounds killer with the Terminator arm. Couple of questions...

Is that a PTP4 or 3? I haven't heard any reports of anyone running a 50hz motor with the PTP4, just curious if yours is.

Your plinth looks terrific by the way, is it a solid hunk of maple?

[Scott F.]

 

[lofreek]

The PTP in question is a 4. The motor is a 60hz. The maple block isn't one piece. The photo below will show.

[bpape]

Great build.  That's a great looking piece (and bet it sounds pretty sweet too!)

Bryan

[lofreek]

With my V15vxmr, my second string cartridge, it's fantastic.  I want to do some comparisons between my VPI Scout and LarryLenco using the same cartridge, so my prized Soundsmith - Dynavector will get installed after I capture some 24/96 audio from the VPI.

[Hebrew Hammer]

This is beautiful!!!!

[toxteth ogrady]

If the Lenco drive system and the Terminator arm are correctly dialed it won't even be close. Bye bye Vpi. 

[lofreek]

If the Lenco drive system and the Terminator arm are correctly dialed it won't even be close. Bye bye Vpi. 

That was the intent! And trust me, my Scout was performing very well. I am quite meticulous about my turntable setups, having been doing them for close to 40 years.

[sturgus]

Looks great, when can we hear it?
Sturgus