0 Members and 1 Guest are viewing this topic. Read 8908 times.
Any word? I am waiting for a call from VMPS with a tracking number...
The 12" sub kits in the LSW cabinets shipped today, should arrive end of the week.
Your sub arrives tomorrow.When you get your amp please notice the "EQ" section which should be used to notch out the floor-to-ceiling room mode that does not yield to placement or other remedies.Measure your ceiling height, which will tell you what mode frequency to cut. Using a Q=0.25 cut the following frequencies by 3 to 4 dB:8ft ceiling 71Hz9ft ceiling 63Hz10ft ceiling 56HzAlso be sure to do "putty pinching" as per the instructions here. This will trim system Q to your equipment, speaker wire, and associated equipment. A fingernail full of putty at a time removed from the center of the PR is all you want. Go slowly.If your ceiling is taller than 10 ft simply divide the number 565 by its measured maximum height, then cut that frequency.Example: 12ft ceiling = 47Hz.
Carrier is UPS. There are two boxes, as we ship the base separately. Attach the base with the enclosed woodscrews, opening in the front.
Mine are rescheduled for Monday - guess I would rather work from home Monday
That sucks... I don't get it. All the way to monday from today? Mine was to be delivered today, maybe tomorrow for the actual sub? I don't have a tracking # so I can't follow it right now.
I think they were originally Friday
I think I have 10ft ceilings in my listening room, but I will re-measure and set up accordingly.
Be sure to take frequency measurements as well for yourself. Depending on sub placement the largest bass hump in your room may not be the floor to ceiling dimension, and you cannot assume that the math will point you to the correct frequency problem spot either. These formulas work in solid concrete rooms and need to be adjusted for standard stud type construction.