I think it's the best value out there, works nicely. The parametric eq is a great addition. Try it, it will only cost a sum total of about $20 in shipping if returned, 45 day trial period. Over 1000W 4 Ohms, but the printed material is inconclusive whether that is RMS or peak. The down side is that the speaker output is wire terminated with quick-disconnects, so you will need to get 2 blade connectors to to try it. Also, if input does not exceed a certain threshold, after a few minutes it goes to standby, then there is a brief turn on delay when the threshold is exceeded (noticeable during classical with quiet or low-bass energy passages). Beyond that, a gem for its intended purpose. I wish more would try it to increase feedback.
Footnote: I believe, for audiophile use, if only one sub employed, it really either must be dead center & slightly closer than the L-R speakers or integration is below minimum requirements. If that position impossible & superior integration is required, plan on 2 subs, one each sited near each L-R spkr.