I picked up my DBA-1 yesterday and I'm trying to play around with the output levels, but I'm having troubles programming them with the BR-2 remote.
As per the instructions, I hold down the CODE key until the red lights flashes a few times. I then enter the code 250, 251, 252 or 253 to reduce the output level by 0, -1, -2 or -3.
My problem is that after the right light has flashed and stays lit, I enter my code and the red light goes off and the buttons I'm pressing now correspond to changing the input selector. So entering 253 for example will put me on OPTO2 input and I don't get to the point where the remote flashes to say it's excepted the code.
Any ideas what I'm doing wrong. This seems so simple, but it doesn't work for me...
Wayne.