FryCleaner Wire Burning?

0 Members and 1 Guest are viewing this topic. Read 2102 times.

ABEX

  • Full Member
  • Posts: 777
FryCleaner Wire Burning?
« on: 9 Dec 2003, 10:45 am »
I was wondering what the effect of burning a 1000' spool of 24ga. solid core wire would be?

Is there just to much resistance for it not to have adequate effect?

TIA

hagtech

FryCleaner Wire Burning?
« Reply #1 on: 10 Dec 2003, 05:11 am »
It should work.  A thousand feet should have less than 100 ohms resistance.  Just short the far end and drive one side with FryKleaner on high.  Can do four spools at a time this way.

jh :)

ABEX

  • Full Member
  • Posts: 777
FryCleaner Wire Burning?
« Reply #2 on: 10 Dec 2003, 08:40 am »
Thanks!
I set it up to run from Positve to negative the way you would with an IC's I think. I used a piece of wire with Allegator clips at both ends attached to Pos. & Neg. sides.

The Solid Core wire is single wire no pos\neg. legs to be concerned with.Therefore I just ran it straight.

Hope that made sense.L :lol: