[alpa6]

Im about to finish up my piccalo r 10 has two values in the manual.One schematic says 221.This is what i put in it.The parts list says 232 should go there.Which is right? Their pretty close in value does it matter?

[alpa6]

no one built a piccalo yet?No one see the problem in the manual?The parts list says 232.The resistor schematic says 221.What do i put in?I already put 221's in there.
Jim you there? whats the right value?I want to finish it up tommorow.I guess i could try what i have in there now.It within 10% of 232 but id like some guidance.

[hagtech]

Put in the 232.  It was a late change to the design.

jh

[alpa6]

Oh my i think i killed my piccolo.I accidently put s1 into s2.In order to get it out i pulled out a trace.I reinserted it and got solder on it so i got contact.Only one side works now.The other side is very low in volume.Mostly i just get tube rush.The light does not come on.Ive measured all the resistors around s1.All the resistors come out  similar.Any ideas what i might do to check for whats wrong?The left sides  the bad one.I was able to connect the trace with solder and it is getting voltage.

[alpa6]

I was able to connect the exposed wire with solder.I measured the exposed wire and do have voltage there.