I was asked by F-100 to prototype a "nice" case for his Promitheus TVC to replace the stock Merbau case. I took this modded TVC from him as partial trade for the commission. I used this single input TVC to prototype the case and liked it so much I acquired a dual input TVC for my personal use. I'm offering this Black Walnut version for sale. Listed below are the "mods" I made to the case. F-100 added better volume controls and wire.
1. Solid 3/4" American Black Walnut with Walnut inlay miter joints.
2. Constrained Layer Damping bottom platform 1-1/8" thick = two layers of 1/2" - 9 layer Baltic Birch ply bottom with a layer of Black Hole Pad between the ply layers for damping.
3. Trannie shells are covered in BHP
4. 3/8" removable gloss black plexiglass top panel.
5. 1/4"-20 inserts tapped into bottom for spikes or feet with common 1/4"-20 thread
6. Oversized solid wood front panel
7. Satin finish
Pic of the case before mounting the TVC internals.
I have not yet decided if I will include the stock Ebony knobs or turn new wood inlay knobs so the walnut front plate has not yet been mounted or drilled out.
I have been listening to this preamp for a couple weeks now connected to both my Symphonic Line RG4 and Odyssey Dual Mono. This preamp disapeares in my system
Asking
$600 obo $525.00
