Problems with Sharp SD-EX111

eric the red · « **on:** 6 May 2006, 02:12 am »

Due to my own stupidity hooking up new speaker wires, my Sharp went DOA blank and now only clicks when I hit the on/off button. Is there a fix for it or am I forced to go to my backup unit still in box and learn from my $80.00 mistake? TIA

Soundbitten · « **Reply #1 on:** 6 May 2006, 03:33 pm »

Quote from: eric the red

Due to my own stupidity hooking up new speaker wires, my Sharp went DOA blank and now only clicks when I hit the on/off button. Is there a fix for it or am I forced to go to my backup unit still in box and learn from my $80.00 mistake? TIA

That happened to mine ( all I did was turn up the volume ) while it was still under warranty . Sent it in for repairs and they sent me back a different refurbished unit . This one has worked fine .

KKM · « **Reply #2 on:** 6 May 2006, 03:34 pm »

Eric, did you try unplugging unit for a few minutes and plugging back in?

eric the red · « **Reply #3 on:** 6 May 2006, 05:56 pm »

Quote from: KKM

Eric, did you try unplugging unit for a few minutes and plugging back in?

Yes and is still DOA after sitting all night-guess I'll get ahold of Sharp and see what they say