X-Statik Crossover Upgrade - .1 microfarad Sonicap

0 Members and 1 Guest are viewing this topic. Read 188 times.

Ben Toskey

  • Jr. Member
  • Posts: 3
X-Statik Crossover Upgrade - .1 microfarad Sonicap
« on: 27 Jun 2020, 07:55 pm »
Hey Guys- I am mostly done upgrade my X-Statik Crossover. The (1) component left is the .1 mf Sonicap. I'm not too handy with electrical diagrams, so I'm a bit confused about where to place it.

Do I put it across C1-C2 and keep the other components present? Any explanation or a pic would be very helpful!

Here is the whole board in its current state



Here is the component in question held above the suspected installation point.



Danny Richie

  • Facilitator
  • Posts: 13163
    • http://www.gr-research.com
Re: X-Statik Crossover Upgrade - .1 microfarad Sonicap
« Reply #1 on: 28 Jun 2020, 01:12 am »
That cap just by-passes those two caps in your picture.

You can just twist them onto the 20uF ply cap and solder them on.


Ben Toskey

  • Jr. Member
  • Posts: 3
Re: X-Statik Crossover Upgrade - .1 microfarad Sonicap
« Reply #2 on: 28 Jun 2020, 09:22 am »
Thanks for the speedy answer Danny! Really appreciate all of your help throughout this project.  :thumb: