Remote Kit Question

mgalusha · « **on:** 1 Nov 2004, 04:04 am »

Kevin,

I have been asked about installing one of your remote kits inside a preamp. I had a look at the kit at RMAF and it seems nicely done. Can you provide the dimensions of the board so I can determine how much room will be needed and thus if this is feasible?

The board wasn't very large if I remember correctly but dimensions would be great. I looked at your site but didn't find this information. Looking at the pictures and going from memory I'd guess it's about 1.5 x 4 inches.

Thanks,

Mike

Kevin P · « **Reply #1 on:** 1 Nov 2004, 05:56 pm »

Mike,

Yes... thanks for asking. I've updated the web page to reflect the size.

The actual size is 35mm wide by 102mm long (1 3/8" x 4") so your pretty close on your guess.

The board can be located anywhere in the chassis as the IR port can be attached via a ribbon cable.

mgalusha · « **Reply #2 on:** 1 Nov 2004, 11:39 pm »

Kevin,

Thanks for the reply. I will order the kit today or tomorrow.

Mike

YoungDave · « **Reply #3 on:** 15 Jan 2005, 04:40 am »

Any way to get a remote for Noble pots? My pre uses 2 - 25k Nobles. Might be nice to have so I can set vol & bal from listening position, but I don't think I want to go to the Alps pot & I really think its 25k I need anyhow...

Kevin P · « **Reply #4 on:** 16 Jan 2005, 09:26 pm »

The remote board is good with any motorized pot that can work with 5VDC to control the motor. I'm not sure there is a motorized Nobel easily available. You would have to do some searching. I've only used the Alps units to date.