« previous next »
Pages: [1]   Go Down

Greeting and Salutations

0 Members and 1 Guest are viewing this topic. Read 588 times.

soopaman

  • Newbie
  • Posts: 1
Greeting and Salutations
« on: 1 Feb 2016, 02:16 pm »
I've recently been bitten by the speaker building bug and would like to start learning as much as I can about speaker building, DSP settings and configurations, and passive cross-over designs. I know it sounds like a tall order but I'm up for the challenge. This is more of a hobby for me, and a way for me to blow off steam and keep they grey matter between my ears from shriveling up  :D. I look forward to learning as much as possible from each and everyone of you. Thanks.  :thumb:
Logged

FullRangeMan

  • Facilitator
  • Posts: 20894
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: Greeting and Salutations
« Reply #1 on: 1 Feb 2016, 02:26 pm »
Welcome Soopaman :thumb:
Logged

Blackmore

Re: Greeting and Salutations
« Reply #2 on: 1 Feb 2016, 02:30 pm »
Welcome! You'll find lots of good info on speaker building here.
Logged

FullRangeMan

  • Facilitator
  • Posts: 20894
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: Greeting and Salutations
« Reply #3 on: 1 Feb 2016, 02:39 pm »
Quote from: soopaman on  1 Feb 2016, 02:16 pm
I've recently been bitten by the speaker building bug and would like to start learning as much as I can about speaker building, DSP settings and configurations, and passive cross-over designs. I know it sounds like a tall order but I'm up for the challenge. This is more of a hobby for me, and a way for me to blow off steam and keep they grey matter between my ears from shriveling up  :D. I look forward to learning as much as possible from each and everyone of you. Thanks.  :thumb:
Why DSP and xovers?  why not run a fullrange driver direct in the amp w/no xover?
Solder the speaker cable direct in the FR driver-no fancy connectors.

There is only 3 components:
Driver
Speaker cable
Enclousure
« Last Edit: 1 Feb 2016, 03:41 pm by FullRangeMan »
Logged

ArthurDent

  • Full Member
  • Posts: 16027
  • Don't Panic / Mostly Harmless
Re: Greeting and Salutations
« Reply #4 on: 1 Feb 2016, 02:51 pm »
Greetings & Welcome to AC soopaman  :thumb:
Logged

Phil A

Re: Greeting and Salutations
« Reply #5 on: 1 Feb 2016, 08:50 pm »
Welcome to AC!
Logged
Pages: [1]   Go Up
« previous next »