[DTB300]

I do know this is Rigid Fiberglass....but can it be bent or curved slightly???  I do not have any to try out, so I thought I would asked the group here.    Or will it break apart like EPS?

[bpape]

You can bend it slightly - not a lot though.  Might have better luck with 703 bending a bit more. Whatcha tryin' to do?

Bryan

[DTB300]

Put behind a slightly curved panel.    Tried to find a good example of the curve, as I do not have a picture with me.  I would say the curve is similar to the RPG BAD curve but bigger.

So the 703 with lower density will bend easier than the higher density 705

[bpape]

Yes. Like I said, all depends on how much you need to bend it.