So I have finally received my custom case and it is a beauty! I will show when its all done. Its a three channel case that is 2U and custom made to support three amps and power supplies, along with xlr only connections and bi amping for all three channels! And this time, it actually provides ventilation, unlike some other cases... My question is about the power application. I have purchased, in the past, molex connections for my custom connections, but now I am feeling a little bold and want to try direct soldering of the power supplies. Is it possible, there is any benefit, or is such an endeavor just all potential downside? Has anyone ever done this? If I did it, whats the best way to insulate the soldered connection?