Keeping the pricing the same, we have made some changes to the build. Now rather than using the original circuit board for layout, the entire unit will be built point-to-point wired.
We can also perform this service for owners of the original Jolida 302A/502A series amplifiers.
If you have the original MK I series, we will upgrade to the MK II if you so desire.
Details in BOLD below are new updates.
Details:
* Custom built hardwood chassis - Tell us what you want--ie; symmetrical design with mains transformer in center or with mains tranny to left side as in our custom unit we showed a while back.
Cherry, Black Walnut, Bubinga standard --- Curly Maple or combination of woods additional
* Original mains and output transformers used from your unit
* Original circuit board is maintained. All copper tracing is removed and board is rebuilt using all point-to-point techniques. All new wiring is used throughout.
*Original circuit board trashed and new circuit is built using all new point-to-point wiring.
* New gold plated tube sockets x 8 pieces
* All new resistors and coupling capacitors are used. (complete new circuit)
* New high quality output binding post (if you already have WBT binding post, we will retain these)
* All new RCA input jacks
* Cryogenic treated silver IEC (or power con connector) and fuse holder
* New high quality 10 turn potentiometers used for precise bias adjustment
What you end up with is a brand new unit with only your original transformers and in some situations, your coupling capacitors being used.
-- Signature units with new SoniCap Gen II coupling capacitors: $1795
-- Platinum units with new SoniCap Platinum Teflon coupling capacitors $1895
-- Reference units with new V-Cap Teflon coupling capacitors: $2200
-- Platinum and V-Cap: $1795 if we can use coupling capacitors currently in your existing amplifier.
-- JPS Alumiloy input signal wire - add $25
-- Noble Volume control - add $40
-- DACT attenuator - add $225
-- New Hammond output transformers - add $275