[robbiesurp]

Is there any problem hooking my Bent Audio MU step up transformers for break in with the FryKleaner? I think they are set at 1:10 gain now. Which volume setting should I use on the FryKleaner? Is there a certain signal path that I need to use when hooking them up?

Thanks

[hagtech]

These trannys can handle huge signals.  I used to burn them in using the HI setting.  For current mode burn, I would short the outputs.  That puts the ESR of the secondary as the load.  Forces the core into action with a lot of flux.  You might prefer a compromise, use a 1k load instead.

jh

[robbiesurp]

Thanks Jim!

Does this mean that i can run them into one side of the frykleaner and then out to the other set of inputs on the frykleaner? Sorry for my lack of technical knowledge.

[hagtech]

Just drive the primary side.

jh

[robbiesurp]

Just drive the primary side.

jh

Does this mean connect the J2 & J3 outputs of the Frykleaner to the inputs of the MU only? Nothing is plugged into J4 & J5 on the Frykleaner and the outputs of the MU are not connected to anything either? Just want to clarify this. thanks!

[hagtech]

Yup.