[mv038856]

Hi James!

I was wonderng where to find the RS-232 codes for the SP-1(PRO)!?

On the Bryston web site I found some documentation for the SP-1.7, but neither the SP-1, nor the SP-2 are mentioned. Someone asked the question about the SP-2 codes (whether they changed from the SP1.7) in another tread, but I couldn't find an answer there.

I recently acquired a Crestron Processor and adapted the user module provided for the SP 1.7 on the Bryston web site. However, the only commands that seem to work on my SP-1 are the power up and the power down...  

I am planning to upgrade to the SP-2 anyway, but I want to find out whether the SP-1 not working with that particuar software version is due to not supported RS-232 commands, a RS-232 communication problem  or my programming expertise...  

Thanks

Markus aka mv038856

[James Tanner]

I will check with Mike Pickett on this one.

james

[mv038856]

Hi James!

Did you get the chance to ask Mike about the RS-232 codes?

Thanks


Markus

[James Tanner]

Hi James!

Did you get the chance to ask Mike about the RS-232 codes?

Thanks


Markus

The SP2 codes are, for the most part, identical to the codes for the SP1.7.
 
Here's a link to the 1.7 codes:
 
http://bryston.ca/pdfs/SP17_RS232_051.pdf
 
At some point we will publish a complete protocol for the SP2 including any changes, if applicable, and post it on our website.
 
Thanks,
 
Mike Pickett
Engineering Technician