« previous next »
Pages: [1]   Go Down

Piccolo Build - Terminal Shields

0 Members and 1 Guest are viewing this topic. Read 1220 times.

bluenoteJML

  • Jr. Member
  • Posts: 34
Piccolo Build - Terminal Shields
« on: 30 May 2010, 02:19 am »
Hi - Piccolo build is moving along.  Still waiting on some parts but have a question about the terminal shields.  The manual doesn't say so I'm guessing that they go on the underside of the pcb.  What are they used for?  They seem to be in the way of the batter holder but I could also have them placed in the wrong holes (haven't soldered them yet at least).  Thanks.
Logged

analog97

  • Full Member
  • Posts: 373
Re: Piccolo Build - Terminal Shields
« Reply #1 on: 30 May 2010, 03:04 am »
No, on the same side as the other components.  Just behing the row of electrolytic cap.  You will see the holes for them.  Look again. :D
Logged

bluenoteJML

  • Jr. Member
  • Posts: 34
Re: Piccolo Build - Terminal Shields
« Reply #2 on: 30 May 2010, 03:20 am »
Saw the holes, just couldn't see them in the picture in the manual.  What is their purpose?
Logged

analog97

  • Full Member
  • Posts: 373
Re: Piccolo Build - Terminal Shields
« Reply #3 on: 30 May 2010, 03:28 am »
You have to look closely, VERY closely to see them in the picture.  They are for shielding. 
Logged

bluenoteJML

  • Jr. Member
  • Posts: 34
Re: Piccolo Build - Terminal Shields
« Reply #4 on: 30 May 2010, 03:31 am »
I had both eyes open, I swear.  I'm going to blame it on my printer.  :) 
Logged
Pages: [1]   Go Up
« previous next »