[Danny Richie]

What are you planning on using in the V2 kit for hooking up the subs to the amp?

I hook the wire leads that are already on the amp straight to the lower woofer then run a jumper from the bottom woofer (easy since there are two terminals for + and -) to the top woofer. No binding post needed either.

Also, these are my first OB subs are they supposed to be wired out of phase. I seem to recall that.

Nope, just wire them normally. If you need to flip the phase then there is a 180 degree phase switch right on the amp.

[dvenardos]

The W-frames are only 24", I think maybe I will build a slide out amp enclosure for them to sit on and then drill a hole in the bottom of the W-frame to pass through the wires from the amp. That way I can put grills front and back.

[Danny Richie]

Just remember that if you drop them into a W frame and flip one woofer around facing the other direction to be sure and flip its polarity too.

[dvenardos]

Ah, that is what I was thinking of. Thanks.

Just remember that if you drop them into a W frame and flip one woofer around facing the other direction to be sure and flip its polarity too.