[shedman]

When i first built my cornet it was in a hammond chassis it looked bad ,after reading lots of old posts i decided to upgrade the parts as well .My woodwork and metalwork skills are far better than my electrical .I am very happy with the looks and sound

[Mr Ed]

If it sounds as good as it looks your in for a treat!

What wood, and how is it finished ?

Ed

[shedman]

Hi  Ash base then veneered with Macassar Ebony.Finish = sanding sealer 3 coats ,Danish oil 3 coats ,rubbing down between each coat up to 1000 grit.No wax. Plan to change chassis on my st35 amp (clone) to same ,matching pair should look good  cheers

[satai74]

What did you use as signal capasitators?
You using 47uF for the rectifier tube?
I thing for 5y3 tube u should use 10uF, or am i wrong?
Atleast it says so on 5y3gt datasheets.
But on hagermans it says to put 47uF, which to my knowledge shortertens the life on rectifiertube.
Correct me if i am wrong

Edit: and this looks stunning!