[sailender]

HI

How to pair Integrated amplifiers with Emerald physics CS3?

I do not know how a conventional  integrated amp can be connected to Behringer DCX2496.

Help needed

Sailender

[sfdoddsy]

Normally they can't be. It need to go between a preamp and the power amp.

[Clayton]

Hi Sailender,

The DCX2496 can be used in the tape loop of your integrated amp, if it has one. Many current integrated amps do not feature a tape loop.

Clayton Shaw
President | Emerald Physics

[sailender]

Thank you for the info.
I have sent a Private message to you.Please Check it Sir.

[sailender]

Solution given by zybar on: 7 Nov 2009, 12:01 PM

"Your source goes into the DCX and the output of the DCX goes into the RWA integrated.  Basically treating the RWA as a power amp.

Depending on the cables being used, you might xlr adapters as I don't believe the RWA gear has balanced connections.'


Solution given by Raindrop audio Singapore for Marantz SA11S1 CD Player +Signature 30.2 integrated

"The output of the the Marantz SA11S1 CD Player is 5V RMS balanced, high enough to go directly into the crossover without needing gain from a pre-amp. The output from the crossover can go into the Signature 30.2 integrated which is a great match with the CS3. This setup is very cost effective. However one cannot add other sources."

[sailender]

I have recently ordered Emerald Physics CS3.
Need members help in identifying cost effective pre/power amp set up for these speakers.

[Nyal Mellor]

ATI? 4 channel 1804 at $1800 or so? http://www.ati-amp.com/at1800.html