[Neon]

Hi Circle
  I have a WTT Classic w the carbon fiber arm.  The Bearing Cup has the Marigo mod which is a brass clamp which completely surrounds the cup.  The cup was attached to the plinth with a square adhesive coated piece approx 1 inch square by maybe a couple of mm thick which fits between the plinth and the  (almost looks like a double sided adhesive rubber patch) This may have been part of the Marigo mod, done by the previous owner, and the adhesive square actually elevates the cup a little (needed to accomodate the clamp which protrudes below the cup).  Now that the adhesive is failing, any suggestions on how to reattach the cup to the plinth ?
Dana Woods WTT Classic, WTT Reference

[Mike Pranka]

You could use a square of 3M adhesive foam..  or I'd probably just juse a bit of silicone and let it set. The silicone should hold fine and you could still remove the cup at any time if necessary.

Mike

[Neon]

Mike
  Thanks much.  Ever hear of this happening ?  What do you think of this Marigo mod ?
Dana