Hi, what I don't understand is how you would connect the top and the bottom set of tube connectors together if you are just running one amplifier - the male ends would need to either have a 45 degree entrance or allow a second set of connectors to slide into the back of them, So you could loop the wire to the second set of tube connectors .... ( please see other examples below )
-----------------
so I usually use a bare wire on a 5 way binding post -
other people use a Bar connector -
---------------------------------------
Here are some examples for Banana type connectors ---
these use a 45 degree attachment point
Klei stacks their connectors
1 -
2 -
-------------------------------
here are two other ways some do it ...
1 -
2 -
----------------
Any ideas - thank you