I am not meaning to be a tease. I just wanted to make sure it was going to happen before I put my foot in my mouth and said something was going to be there.
I have been working on a project for months now and I have been counting on someone else to get the cabinets gone and to me in time. It is coming down to the very last minute.
In fact I have two different speakers coming down to the last minute.
Plan A, for the ball room (30' by 38' room), I have an open baffle line source. It has a front baffle that looks a bit like the LS-9. It uses the same tweeters (9 of them) but in free air. It also uses twelve 6.5" woofers, but they are quite different than the woofers in the LS-9. These woofers are designed to play in free air. So that is the front baffle...
20" back from that is the rear baffle. The front and rear baffles are linked with an inner frame structure. The sides are open. The rear baffle supports six 12" woofers (all SW-12-16FR's). They are all direct servo controlled of course. So they will have a flat response to below 20Hz with absolute control and EQ system.
In the center of the structure there is a wedge shaped divider facing the front baffle to defuse the back wave and keep it from reflecting off of the rear subs. This wedge shaped center structure will be lined with No Rez as well to not only deflect but absorb a bit too.
I'll try to get some pics of the empty boxes to post tomorrow.
I have something really special for my smaller room as well, but won't announce it until I know for sure it will make it to the show.
So hang in there. More to come.
