RM30s - corner veneer

KJ · « **on:** 31 May 2005, 08:24 pm »

Has anyone had any issues with the corner veneer not being glued down quite right? One of my RM30's has a one inch section of the corner wrap near the baffle that didn't remain flush when built. I've ignored it until now, but I'd like to see if I could heat up the adhesive and apply force to press it into place.

Anybody have any suggestions? I was thinking of using a hair dryer to heat the adhesive, but I'm afraid I might damage the finish.

-KJ

KJ · « **Reply #1 on:** 3 Jun 2005, 12:40 am »

Brian - any suggestions?

-KJ

Brian Cheney · « **Reply #2 on:** 3 Jun 2005, 01:01 am »

A cabinetshop should be able to fix the problem. Why not send us a picture?

KJ · « **Reply #3 on:** 3 Jun 2005, 02:58 am »

Quote from: Brian Cheney

A cabinetshop should be able to fix the problem. Why not send us a picture?

I didn't want to lug the speaker to a cabinet shop if at all possible. Any idea what type of adhesive is used? If I do take it in, I assume the 5 year warranty will cover the cabinet shop's fee?

I'll try and take a close up shot tomorrow afternoon when there is more light.

-KJ

Brian Cheney · « **Reply #4 on:** 3 Jun 2005, 02:35 pm »

We will replace the cabinet under warranty if that is cheaper than a local fix. Email the pix to [email protected].