Okay! I'm home & have the flat pack out, its in perfect shape, plenty of soft foam on all sides to keep everything safe and in place. Thr cuts are also super clean.
I also test fit the BG Neo3 I have on hand, mostly To check the clearance and fitment. (Including the little 3D printed bars)
I also did a dry test fit for ideas on how best to assemble it.
Its probably a good idea once test fitment is done, to mark the bottom of the slope as well as each left and right panel to make sure I have their position and orientation correct when it comes time to properly glue them together. Cuz I put the slope in upside down & backwards the first time.
My next step will be to get some clamps, glue them together and seal them with shellac. (I assume its okay to put that on before i apply the veneer to the sides/back? Or only to the parts that will be painted?)
Thanks Jay for the flatpack! These are perfect!