0 Members and 1 Guest are viewing this topic. Read 88843 times.
Jay posted a comprehensive set of wiring diagrams for the different possibilities of driver configuration. You can find those here https://www.audiocircle.com/index.php?topic=149708.msg1600884#msg1600884 The reason both sets of terminals are used is because one set is for the driver coil and the other set is for the servo control coil. You have to use both, they have to be properly connected together, and connected to the correct pair of wires on the amp.Mike
I have another noob question. I'm finding it difficult to locate 1" MDF in my area (northern NJ). Would it be feasible to glue two 1/2" sheets together for the main baffle? Or should I look for 1" plywood or some other material?
If you are using a HX800 amp the color codes are different for each channel, so get them wired correctly. If not one half the sub is reversed polarity and cancels the output from the other side. Took me a while to figure that out.
Page created in 0.04 seconds with 29 queries.