S Clark and 5 Guests are viewing this topic. Read 165147 times.
I'm out of boards again.
I'd be happy to print some boards, if there was a min order.[/b] It takes about 25-30 orders, of both boards. But so far since I've run out it's been a slow trickle, so it's hard to assume that I can get that min order.
Just completed my latest Folsom amp. I couldn't find a case I liked, so I built my own. I am totally blown away by the sound quality of this one. It's my fourth build, but this one has the Antipole PS with a Lundahl transformer powering it. The amp has the stock BOM except the input caps are Clarity ESA. I have about 100 hours on it, and it is by far the best sounding yet. I have previously only used an SMPS to power these amps. I just can't get over how good this new one sounds. I can listen for hours without fatigue. Jeremy: This is one great design, and I hope you decide to offer another batch of cards so many others can build, and enjoy this superb sounding amplifier!
How did you wire up the LED for the front power button?
I've been enjoying listening to my Folsom 7297 amp and since completing the Pass B1 buffer and placing it before the amplifier it even sounds better . The transformer makes a little noise but unless you're sitting next to it it is not an issue . The amp is pretty revealing and has good treble and low end reproduction .
Page created in 0.055 seconds with 28 queries.