[lawofcpln]

Hi all.  I'm trying to fix my Onkyo receiver and have been having some trouble finding a particular part.  I'm hoping that one of you may know where to get it.  I ordered the part from analogmetric.com but they sent the wrong part and won't respond to my emails to fix the problem.  I'm looking for a Cement 0.22 Ohm x2 2W Non-inductance Resistor.  Here is what it looks like:

[paul79]

It is just 2 resistors in one package... One of the legs (center?) is common, so just use 2 resistors. Should be pretty easy to make them fit and look good.

[S Clark]

The .22OhmKX2 could be read as .22ohmK times 2.  I'm just wondering if you have a 220ohm resistor instead of a .22 ohm one.  If you have one leg that's still good, I'd measure it just to make sure you've got the value right.

[paul79]

It's definitely .22 ohm X 2, 2 in one package. Most likely emitter resistors. I'd be checking those outputs, then drivers, look for other open resistors in the amp, pre drivers.... Make sure all this is good too!

[lawofcpln]

Thanks everyone.  I've already tested the part, found that it was bad and removed it from my receiver.  I just need to know where to buy a replacement part (but not from analogmetric.com).  Any of you have a good source?

[paul79]

These are 5 watt, but they will do fine. 3 watt is impossible to find in this configuration, and all you will get in a 2 in 1 package will be old stock at this point.

http://www.ebay.com/itm/8-X-MADE-IN-JAPAN-KOA-BPR55-DUAL-0-22R-0-22-OHM-5W-10-NON-INDUCTIVE-RESISTOR-/400772599961?hash=item5d4fe89099

http://www.ebay.com/itm/5-pcs-3pin-0-22-ohm-X2-5Watt-R22K-/131612795130?hash=item1ea4bbe0fa

[lawofcpln]

Thank you Paul!  Analogmetric.com sent a 5w part so maybe they are not so bad.   I didn't know one could use a 5w to replace a 2w part!

[paul79]

The only thing that will take them out in this emitter resistor position, is a blown output. Oversizing "this" resistor is no big deal.