0 Members and 1 Guest are viewing this topic. Read 284975 times.
and what about if using in active setup where to put it?..not sure but i am planning to usedual smps with the Ncore module ....does that ans?V
If someone has experience with both NC400 and NC1200, I would appreciate your comments. . .
If you are not able to run the NC1200 amps full range and had to pick where to put it, it should go on the mid / top end IME. Put the NC400 down on the bottom. Of course there are many variables but I'd say this would be the way to go.
On the topic of Ncores, I have an issue I'm hoping someone might know a fix for. I've had the modules for a couple months and (with the exception of lodging a screw in the aluminum plate) haven't had any issues. Due to laziness, they weren't in a chassis for a while (but grounded). Recently I put them in a chassis and was initially having some issues getting audio (a speaker wire broke off in the terminal on the module, possibly coupled with grounding issues, I got the modules working). Recently however, both modules are having some really weird and disconcerting issues. It started when turning the modules on after a couple hours of use (historically, I had left them on all the time). When I turned them back on, one of the modules wasn't producing sound. I opened it up, moved some stuff around, and got it producing sound again (no idea what the exact fix was). This is one concern. The bigger concern however is that when I shut this module off now (and the other though to a lesser extent) it makes a spastic clicking noise (like when turning on) at least ten times and very quickly. All the while the leds are flashing. Then, it shuts off. The other module does this too though to a lesser degree. I'm certain I've never had this issue prior. My only thought is that it might be a ground issue. Right now all the grounding is fairly standard. On the XLR input I have the +/- wired normally with a case ground on the third (ground pin) furthermore the sleeve of the xlr cable is grounded to the xlr connector at the ground tab. I highly doubt this is the problem but hopefully it is and doesn't necessitate returning the modules. Has anyone experienced anything similar or have any ideas what it might be? Please share if so.
I don't know if this belongs or not? If not please move to correct location. Question, what preamps are people using with the ncore amps either the 400 or 1200? Thanks!
deHavilland Ultra Verve 2 or 3