GAS Flea Market thread

0 Members and 1 Guest are viewing this topic. Read 92620 times.

Scott F.

Re: GAS Flea Market thread
« Reply #460 on: 16 Jun 2018, 11:50 pm »
Hey James,
I'll take the Micro Seiki. I'm a sucker for turntables :duh:
PM sent

Vapor Audio

  • Industry Participant
  • Posts: 2023
  • Building Audio Bling since 2007
    • Vapor Audio
Re: GAS Flea Market thread
« Reply #461 on: 21 Jun 2018, 10:53 pm »
Hey guys, I could stand to sell some gear.  It's been a rough last 2 years, right now I'm stuff rich and cash poor … all of this is being offered just to help cover my bills for life.  Since my situation is getting close to necessity, I'm offering everything near the bottom end of what I think going prices should be.  I'll try and get back here to check PM's, but best bet is to email me at ryan@vaporsound.com if you see something you want.  Any purchases would be much appreciated! 


Technics SP-15 table in a nice MDF plinth with Syntec S-220 arm, Orsonic headshell, and the pictured AudioTechnica isolation feet included.  Lots of manuals and paperwork included as well.  All controls (speed and pitch) work as they should, table spins free and quiet.  I've never put a cart on it, but should be a good sounding table for the money.  $400




Rega Planar 3 with Grace 909 arm and a Supex MC900 cartridge - this was a project table that I haven't finished.  New ceramic bearing, new belt, plastic hollow spindle platter filled with epoxy to dampen, and Grace arm rewired all the way through (no connectors) with Cardas headshell wire.  New 1877 Audio headshell connectors included too, as is the Herbies platter mat (that's apparently very tasty to kitties lol).  Needs the wires terminated on both ends, and the cart needs to be refurbed since it has unknown hours on it.  But once done, this setup has IMO possibility of punching way above it's price.  $300







Arte Forma P25.2 amp - This was a $2000 amp in 2008 or so when I got it, rated at 250wpc.  Had quite a bit of hum, and Arte Forma support was non-existent, so I took it to Mike Missel and he worked his magic.  Hum was decresed significantly, but is still noticable in a quiet room or with sensitive speakers.  But it's still a nice warm and full sounding amp with tons of power.  Another great deal for a second setup or if you have dome tweeters that don't show the hiss like my RAAL ribbons do $300



Electrocompaniet AW220 amps - I didn't take these off my shelf for the picture, they're both in excellent condition.  They run stereo at 80wpc, or push of a bottom can be used as monoblocks at 220 watts.  These were also taken to Mike Missel for a checkup, and to make sure both were biased identically for monoblock use.  Originally these were $2500 each in the early 2000's.  Electrocompaniet amps have a lightning fast, very resolving sound.  As monoblocks they can rival amps many times what I'm asking, the power as monos gives them fantastic bottom end as well.  $1500 for the pair, or $800 each.  Would prefer to sell as a pair. 



Vapor Audio Breeze - have a good contion demo set with stands.  They're in maple finish, satin black front baffles.  Stands have bamboo front/back accents.  There is one or two small dents on the rear of one speaker, nothing noticable without looking for it.  If you have a monitor with 5-6" woofers currently, whatever they are these are gonna be better.  RAAL tweeter and Wavecor woofer in time aligned Birch Ply baffle, a design that just came together perfectly resulting in a 4 part crossover.  These new would be $2295, sell locally for $1400 SOLD

http://www.vaporsound.com/speakers/breeze/

And really that's just the tip of the iceberg of what I have I could sell.  I have piles of quality cables from Antipodes, VH Audio, BPT, etc.  I have more electronics, speakers, you name it.  Have a Placette Passive pre, Clayton Audio S100 amp, a few pair of Vapor Audio speakers.  And right now I won't turn down any offer that's even close to reasonable.
« Last Edit: 25 Jun 2018, 04:28 pm by Vapor Audio »

Vapor Audio

  • Industry Participant
  • Posts: 2023
  • Building Audio Bling since 2007
    • Vapor Audio
Re: GAS Flea Market thread
« Reply #462 on: 21 Jun 2018, 11:37 pm »
Thought I had a buyer for these, he just said he can't right now.

Built and designed by me, solid 2-way monitor.  Rear has ambient tweeter with level control and a toggle that can switch phase of rear tweeter.  These lean on the warm, forgiving side with excellent bass for a .75cu/ft monitor.  Will loan these out for a listen to anyone interested, there's more than my asking price of parts inside these as the drivers are quality and they're loaded with Auricaps.  $400 SOLD



« Last Edit: 25 Jun 2018, 04:28 pm by Vapor Audio »

Wind Chaser

Re: GAS Flea Market thread
« Reply #463 on: 22 Jun 2018, 12:23 am »
Hey Ryan,

I hope all is well and moving in the right direction.

Years ago you made a pair RAW OB2X, are those on the chopping block?  I'm up in Canada so I guess I wouldn't qualify if they are, but I did have Al's rough prototypes and I thought they were pretty darn fabulous.

montaldos

Re: GAS Flea Market thread
« Reply #464 on: 25 Jun 2018, 01:02 am »
2 meter Cardas Golden Cross power cord. This is a special label of their golden cross cable that Cardas made custom for Classe Audio. These cords were sold along with Classe's reference monoblock amplifiers. It is a standard Golden Cross cord with special lettering on the shrink wrap.

The condition is physically good... no cuts or serious abrasions. The lettering is faded and there is some dirt/discoloration on the shrink, but mechanically perfect. I rate it a 7 of 10. Works perfectly.

Asking $295 but will discount for a local St. Louis area buyer.

Thanks for looking!











vinyldavid

  • Jr. Member
  • Posts: 34
  • Jaguar!
Re: GAS Flea Market thread
« Reply #465 on: 26 Jun 2018, 09:17 pm »
PM sent on the Technics.  DIBS.

kentj1948

Primare A32 Power Amplifier, Big, Heavy, Great Sounding. SOLD
« Reply #466 on: 16 Jul 2018, 07:46 pm »
I am selling my Primare A32 power amp.  I have owned it six years and it has sounded great while being totally reliable.  This was Primare's statement amp until very recently.  It is designed in Sweden and built in Taiwan.  New it listed for $5500.  It is a great amp for running Maggies or other power hungry speakers.

Power output is 250/400 WPC.  The amp weighs 90 pounds, has a 2KVA transformer and 180,000 uF of capacitance.  It accepts either single ended or balanced inputs and converts single ended sources to balanced.  It is biased slightly on the warm side.  The fins get moderately warm.  I have the box and manuals.  You can get more information at:   

Primare.net>Resources>Past Products>Stereo Amplifiers>A32.

For a serious local buyer, I am willing to do a home audition assuming I get some help moving the amp.  I am willing to meet an out of town buyer so that shipping can be avoided. 

Contact me with any questions or interest.  Thanks for checking out my ad. Kent Johnson 636-399-8053











« Last Edit: 1 Aug 2018, 08:40 pm by kentj1948 »

popthinker

Re: GAS Flea Market thread
« Reply #467 on: 30 Jul 2018, 12:41 am »
Selling a set of Martin Logan Aerius speakers. They sound great, and I'd love for them to find a home with a local AudioCircle member. Can be single or bi-wired. $850.00















daves

  • Full Member
  • Posts: 914
Re: GAS Flea Market thread
« Reply #468 on: 30 Jul 2018, 04:12 pm »
McIntosh 1900 receiver, great cosmetic and working condition , $900 with case, $750 without.
Dynaco A25 speakers, $200, good linen grilles, no badges.




EvanF

  • Jr. Member
  • Posts: 8
  • Kef 104.2xYamaha P2200+Mickey Newbury = :)
Re: GAS Flea Market thread
« Reply #469 on: 5 Aug 2018, 02:11 am »
Dave, any preventative maintenance on the 1900 (caps replaced, etc.?)

daves

  • Full Member
  • Posts: 914
Re: GAS Flea Market thread
« Reply #470 on: 9 Sep 2018, 01:57 pm »
Evan, Alpha Tech cleared up a scratchy channel eight years ago, it if without any issues now.

I am looking for a quality cartridge to mate with a Grado Refence wood tonearm.

vintage9594

iFi Audio Nano iUSB 3.0 Audio-grade USB power supply $150.00
« Reply #471 on: 13 Sep 2018, 01:22 am »
I have a LNIB iFi Audio Nano iUSB3.0 Rengenerator for sale.  This is perfect for anyone that has made the switch to Computer Audio.  It reclocks, rebalances and regenerates the USB signal from your computer to your Dac cleaning up any power supply noise and reducing Jitter as well.

It includes OBM, usb cable, usb power cable and iFi Power supply.

Shipping via USPS priority included in price, PayPal ads fee or F&F....
Thanks

Text to 314-532-0095 for photos or questions