« previous next »
Pages: [1]   Go Down

GM70 Datasheet Error !!

0 Members and 1 Guest are viewing this topic. Read 5239 times.

FullRangeMan

  • Volunteer
  • Posts: 20894
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
GM70 Datasheet Error !!
« on: 6 May 2010, 05:42 am »
Take caution with this GM70 datasheet below, the pinout drawer is wrong in relation to a real GM70 tube.

Logged

FullRangeMan

  • Volunteer
  • Posts: 20894
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: GM70 Datasheet Error !!
« Reply #1 on: 6 May 2010, 05:47 am »
''Image 2'' is the same datesheet pinage drawer with zoom, ''Image 3'' is a real GM70 photo.  There is some diferences, mainly in the thicker pin.

Logged

FullRangeMan

  • Volunteer
  • Posts: 20894
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: GM70 Datasheet Error !!
« Reply #2 on: 6 May 2010, 05:54 am »
This is a correct pinout datasheet drawer taken from other GM70 datasheet PDF file, avaliable at: http://www.shinjo.info/frank/sheets/018/g/GM70.pdf

Logged

FullRangeMan

  • Volunteer
  • Posts: 20894
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: GM70 Datasheet Error !!
« Reply #3 on: 6 May 2010, 06:00 am »
Then the real GM70 pinout is this image/drawer below.   I must thanks to user Kavermei(Kenneth) at other audio forum for help.

Logged

FullRangeMan

  • Volunteer
  • Posts: 20894
  • To whom more was given more will be required.
    • Never go to a psychiatrist, adopt a straycat or dog. On the street they live only two years average.
Re: GM70 Datasheet Error !!
« Reply #4 on: 7 May 2010, 04:08 am »
The ''View Counter'' of this thread is not updating, even after I view various times, look a software problem. :o

Logged
Pages: [1]   Go Up
« previous next »