Hi, I recently bought some Vifa 8 inch and 6 1/2 inch full range drivers.They were in Parts express for dirt cheap.After I got them I finally realized they were 4 ohm speakers.My amp is a Dyna ST-35 with speaker outputs of 8 and 16 ohms.Is there any configuration I can do to,like adding a resistor or cap to make my amp see more of a 8 ohm load,or is it too dangerous to run them to the speakers or amp?My plan was to use only one in each enclosure,and not 2 in series....thanks alot....Mark Korda(mark.korda@myfairpoint.net).