Well my wife said it was finally time to sell off some extra gear. This used to be my main system amp. It has by far the blackest background, no overhang/bloated notes and razor sharp detail I've heard. Hypex rates the UCD400 modules at 250 into 8ohms and 400 into 4ohms. Its being fed by an oversized (1000va) shielded and screened piltron transformer. I had NO transformer buzz at all even straight out of a wall socket. This amp will drive almost anything. I was using it to drive a pair of Magnepan 3.6 and it never seemed to break a sweat. I really loved the detail, but I just wanted a bit more warmth.
Hypex softstart module
Hypex Highgrade power supply
2 Hypex UCD400AD modules
2 S&B TX102 transformer volume controls (1 per channel)
Shallco 23 position switch (for volume)
Shallco select switch
3 sets of vampire copper rca jacks
Eichmann cable pods (low mass binding posts)
wired internally with the same wire as the transformer uses
3 inputs (2 braided and 1 just twisted as an experiment). I didn't move the switch lock pin so it will click past 3, but no sound of course.
I did NOT wire up a mute, because I didn't want to waste any of the transformer taps.
Just for comparison a prebuilt UCD400AD could run you over $1700. Just the raw S&B tx would run over $600 and the switches and jacks aren't bargin bin items. There is a LOT of labor involved in the TVC assembly and its all done here already so its either saving you a lot of time or $.
I'll see it for pretty much parts cost, but as you can see from the part lists I didn't really skimp on the parts. $1850 via paypal or USPS money order with free continental US shipping. I don't charge paypal fees. Obviously I don't have original boxes, but I will pack it VERY well (may have it professionally done on my $).
Pictures (click for larger image)
