« previous next »
Pages: [1]   Go Down

New member: WTC table with a question

0 Members and 1 Guest are viewing this topic. Read 3369 times.

whtlne

  • Newbie
  • Posts: 1
New member: WTC table with a question
« on: 15 Nov 2019, 04:56 pm »
thank you for access to the site.

i have a WT Classic table and the spindle has been upgraded to function with a thread belt. Can someone provide me with the diameter of the belt

thanks
Logged

ADiG

Re: New member: WTC table with a question
« Reply #1 on: 20 Nov 2019, 06:07 pm »
I think your plate has a diameter of 30 cm, therefore similar to the Simplex, for which the polyester thread, will have to measure 492mm.

https://www.welltemperedlab.net/assets/Uploads/WTL-Simplex-Manual-Rev.-August-2013.pdf

Ciao
Logged
Pages: [1]   Go Up
« previous next »