FryCleaner Wire Burning?

ABEX · « **on:** 9 Dec 2003, 10:45 am »

I was wondering what the effect of burning a 1000' spool of 24ga. solid core wire would be?

Is there just to much resistance for it not to have adequate effect?

TIA

hagtech · « **Reply #1 on:** 10 Dec 2003, 05:11 am »

It should work. A thousand feet should have less than 100 ohms resistance. Just short the far end and drive one side with FryKleaner on high. Can do four spools at a time this way.

jh

ABEX · « **Reply #2 on:** 10 Dec 2003, 08:40 am »

Thanks!
I set it up to run from Positve to negative the way you would with an IC's I think. I used a piece of wire with Allegator clips at both ends attached to Pos. & Neg. sides.

The Solid Core wire is single wire no pos\neg. legs to be concerned with.Therefore I just ran it straight.

Hope that made sense.L