Hi Tom,
Overall I am happier with it than I was with a step-up transformer.
To those about to build- I have a couple more construction tips that I picked up during my build that I felt I should share.
1) When drilling the holes, I found if I used a step-drill bit such as the Irwin Uni-bit it gave me clean precise holes that did not require any "clean-up" of edges with a countersink.
2) Since I used a single sheet type sticker for the lettering I had to go back and cutout an area around the ground thumb-nut equal to it's diameter so I got good contact. When there was vinyl material covering the chassis I had some minor hum. The other holes I simply trimmed to the edge with an Exacto knife.
Cheers,
JakeJ