« previous next »
Pages: [1]   Go Down

Getting into the New Tube Rectified supply

0 Members and 1 Guest are viewing this topic. Read 2216 times.

Eric

Getting into the New Tube Rectified supply
« on: 12 Jan 2007, 04:13 pm »
Does anyone know the size of the hex wrench that is required to open the New Tube PS, so one can swap tubes??
Logged

woodsyi

  • Volunteer
  • Posts: 6513
  • Always Look on the Bright Side of Life!
Re: Getting into the New Tube Rectified supply
« Reply #1 on: 12 Jan 2007, 04:18 pm »
Quote from: Eric on 12 Jan 2007, 04:13 pm
Does anyone know the size of the hex wrench that is required to open the New Tube PS, so one can swap tubes??

Dan sends it out with a little allen wrench enclosed. I don't know the number but it's tiny.
Logged

Eric

Re: Getting into the New Tube Rectified supply
« Reply #2 on: 12 Jan 2007, 06:36 pm »
I just got mine, but did not see it in the box. Where was your when you received it. Was it with the cord??

Eric
Logged

woodsyi

  • Volunteer
  • Posts: 6513
  • Always Look on the Bright Side of Life!
Re: Getting into the New Tube Rectified supply
« Reply #3 on: 12 Jan 2007, 07:13 pm »
Quote from: Eric on 12 Jan 2007, 06:36 pm
I just got mine, but did not see it in the box. Where was your when you received it. Was it with the cord??

Eric

Sorry, I don't remember.  I was too excited to get everything set up, I wasn't paying attention.  If you need one I can send you one.  I seem to have a bunch of them -- I don't know from where.
Logged

BikeWNC

Re: Getting into the New Tube Rectified supply
« Reply #4 on: 13 Jan 2007, 12:07 am »
It is a 2mm hex wrench.

Andy
Logged

modwright

  • Industry Contributor
  • Posts: 2655
    • ModWright Instruments
Re: Getting into the New Tube Rectified supply
« Reply #5 on: 14 Jan 2007, 06:52 am »
Sorry, it is actually a 5/64" Allen, but a 2mm probably also works.

Dan
Logged
Pages: [1]   Go Up
« previous next »